![]() I like the glass door so I can watch the mill in action and monitor the crush.Once the selection kit is used the selected building must be placed in the city or the selected upgrade kit must be used on an existing eligible building. I closed in the back of the lower compartment to contain dust but the mill runs slow enough that I don't think there will be much dust floating around. The motor wiring had enough slack that i could neatly run it under the cover and zip tie it away from the drive shaft. I did not like how the power switch was on the opposite side of the grain roller adjusters and the power cord came out the "front" in my set up so I flipped the control housing around. ![]() I had to lower the turntable shelf about a foot so the top would close without hitting the grain funnel. The side hole was barely big enough so I had to remove the fan shroud to slide it in and then put the shroud back on. The cabinet was a little too narrow for the mill so I had to cut a hole in the side to slide the end of the motor thru but it only sticks out an inch when stored. the grain mill was one of those ebay or amazon specials, the DY-368 mill that's running about $150-200 right now.I scored a customer return for a bit lessĪnyway I'll let the pictures tell most of the story. I made a grain mill cabinet out of an old school stereo cabinet I scored on FB for 5 bucks. Since there is no grain mill sub-forum I'll drop this here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |